Login |
Main Gallery » Projects » 2510p SATA caddy » Metal guide removed after unscrewing 2 screws

Actions

2510p SATA caddy

1. Package... ... 16. DVD side... 17. DVD rear... 18. Caddy metal... 19. Metal guide... 20. Top and... 21. Bottom view... 22. Top view of... ... 50. WD3200BEKT_...
 
 
 
Metal guide removed after unscrewing 2 screws
 
 
Remove 2 torqx screws from the 2510p and slide out the optical drive. Close-up of original caddy PATA connector. Remove 2 screw and pull off board to expose the required 2510p connector. PATA connector board removed from caddy
Close-up of the correct 2510p PATA connector below. DVD optical drive above. DVD side screw bracket that needs to be transfered to caddy DVD rear screw bracket that needs to be transfered to caddy
Caddy metal guide that needs to be removed so caddy will fit. Metal guide removed after unscrewing 2 screws Top and rear metal plates from caddy removed to expose LED and connector. This is the top side view.
Bottom view of caddy circuit board. Top view of caddy circuit board displaying Marvel PATA to SATA chip. 2510p bios shot of installed caddy being recognized as a "Notebook Multibay" device.
Bottom gap between caddy faceplate and 2510p chasis Close up of gap Caddy front plate. Non-angled front plate on bottom right which is not flush with 2510p chasis.

Metal guide removed after unscrewing 2 screws

Date: 07/18/2009
70 KB

Exif
Powered by Gallery v2.3